EXTENSION TECHNIQUES

HOW TO PROCESS KERATIN FUSION SYSTEM

HOW TO PROCESS EXTENTUBE SYSTERM

HOW TO PROCESS RING-X EXTENSION

HOW TO PROCESS KERATIP(GLUE TIP) EXTENSIONS

HOW TO PROCESS DOUBLE HAIR EXTENSIONS

HOW TO PROCESS X10D COLD FUSION

HOW TO PROCESS SKIN WEFT

HOW TO PROCESS CLIP IN HAIR EXTENSIONS

How to process Keratin Fusion System

Aside from weaving extension, Fusion System is the most widely used extension system. Since hair must be prepared with glue by yourself, you will have more control over the procedure, meaning you can control the amount of hair to be attached in bulk and the amount of glue applied on extension hair.

Adding Process
**IT IS VITAL THAT CLIENT'S HAIR MUST BE DEEP-CLEANSED AND OIL-FREE BEFORE PROCEEDING.
(DO NOT APPLY CONDITIONER AFTER DEEP-CLEANSING.) FAILURE TO FOLLOW WILL RESULT IN SHEDDING.

Step 1	Step 2-1	Step 2-2
Take some portion of client's hair through template's hole.	Tap the adhesives from the X10+ Station to the end part of extension hair.	As an alternative, you may use X10+ Gun for tapping the adhesives.
Step 3	Step 4	Step 5
Place extension hair under the client's hair.	For well distribution, Roll it until it becomes round and tight.	Finish adding hair, slide out the template and move to next location.
Removing Process
Step 1	Step 2	Step 3
Apply 2 - 3 drops of X10+ Remove.	Pinch the glued part with flat nose pliers and break it.	If residue remains, repeat step 1-2 and comb out.
Warning: This process must be applied by licensed Beauticians only and we strongly recommend enough practices, such as adding and removing process, with gloria mannequin head before proceeding.

How to process ExtenTube System

An increasing number of extension professionals are selecting ExtenTube system for its convenience. Overall, this is the only technique (aside from weaving), in which glue or other chemicals are not required. Therefore, the clients feel free from the usual cautions and warnings (such as avoiding heat or hot water) often instructed by hair dressers when receiving fusion extensions.

Adding Process
*IT IS VITAL THAT CLIENT'S HAIR MUST BE DEEP-CLEANSED AND OIL-FREE BEFORE PROCEEDING.
(DO NOT APPLY CONDITIONER AFTER DEEP-CLEANSING.) FAILURE TO FOLLOW WILL RESULT IN SHEDDING.

Step 1	Step 2	Step 3
Section client's hair.	Insert pulling needle through tube.	Grab a portion of client's hair with pulling needle.
Step 4	Step 5	Step 6
Slide the portion of hair through tube.	Hold the tube 0.5 to 1 inch from scalp.	Insert 909 FlashPoint hair through the tube.
Step 7	Step 8
Flatten the tube.	Finished-You may cut excessive extension hair with nail clipper or leave it.

Removing Process

Step 1	Step 2
Position tube in first groove of Tube Opener and apply pressure slowly.	Slide out the extension hair after opening the tube.
Warning: This process must be applied by licensed beauticians only and we strongly recommend enough practices in adding and removing process, with Gloria Mannequin head before proceeding.